Finishing; Subset Finishing - Xerox 6100BD - Phaser Color Laser Printer System Manual

Subset finishing

System Guide

5 Finishing

The following section contains information about how to use
subset finishing and mixed stacking on a printing job.
The finishing information below does not apply to Continuous
Feed (CF) systems. For CF systems, the finishing
configuration is defined at the CF (STAMPA) Controller. CF
imposition files are used to impose documents for printing in
conjunction with specific CF finishing configurations.
Subset finishing is the capability to use different types of
finishing (or no finishing) within the same job. The ability to
finish subsets independently is a critical feature for many
variable data applications
This product allows more than one type of finishing within a
single PostScript job. The supported finishing options and the
output locations that can be used vary depending upon the
printer type. The finishing options and delivery locations are
the following:
DocuTech 61xx:
• Portrait Stitch
• Landscape Stitch
• Dual Stitch
• Right Portrait Stitch
• Right Landscape Stitch
• Right Dual Stitch
• Bind
• Right Bind
NOTE: The DT 61xx printers allow Short Edge Feed (SEF)
only in paper tray 3, 4, and 5. The short edges of the stocks
range from approximately 10 inches to 14 inches (254mm to
300mm).
5-1