Gateway and Network Configuration
SNMP gateway configuration
Additional features supported in SNMP
Table 0-1. SNMP Supported Features by Product
Feature
Ability to SET Attributes
Localization of Attributes
Finishing Capability for a
Device MIB
1-2
SNMP displays the status of network devices. Using the
SNMP tab in Gateways, the administrator can select among
a number of features and settings for SNMP.
NOTE: SNMP requires a standard license. The System
Administrator must enable SNMP in License Manager.
Xerox recommends the following thirdparty SNMP software
managers:
•
IBM Network Printer Manager (NT)
•
TNG Unicenter (NT)
•
HP OpenView (UNIX, NT)
•
Xerox CentreWare (UNIX, NT)
NOTE: The SNMP manager (for example, HP OpenView)
may have a number of requests into DocuSP for information.
The requested information may not be among the supported
data sets on DocuSP. When this occurs, the SNMP client/
manager displays no value...etc.
NOTE: You can have more than one SNMP manager running
at the same time.
SNMP support for the following features are product
dependent:
•
The ability to SET attributes.
•
The ability to localize text and units of measure.
•
The ability to support a number of MIBs related to
finishing and printing.
•
The ability to perform meter reading automatically.
The following table specifies which Xerox products have
these SNMP supported features:
61XX
EPS 1XX
Y
Y
Y
Y
Y
N
DC2000/
DP/DT
6000/etc
75/90
Y
Y
Y
Y
Y
N
DT100/
iGen
120
N
Y
N
N
N
Y
System Guide