Subaru 2013 Legacy, 2013 Outback Owner's Manual page 199

3-60
Instruments and controls
1) HomeLink button 1
®
2) HomeLink button 2
®
3) HomeLink button 3
®
2. Press and hold the two outer
HomeLink buttons (button 1 and button
®
3) until the indicator light begins to flash
(after approximately 20 seconds). Then
release both buttons.
3. Hold the end of the garage door
opener s hand-held transmitter between
1 and 3 inches (25 and 76 mm) away from
the HomeLink button you wish to pro-
®
gram.
4. Simultaneously press and hold both
the hand-held transmitter button and the
desired HomeLink button. DO NOT re-
®
lease the buttons until step 5 has been
completed.
NOTE
Some gate operators and garage door
openers may require you to replace
this programming step 4 with proce-
dures in "Programming for entrance
gates and garage door openers in
Canada" F3-61.
5. Hold down both buttons until the
HomeLink indicator light flashes, first
®
slowly then rapidly. When the indicator
light flashes rapidly, both buttons may be
released. (The rapidly flashing light indi-
cates successful programming of the new
frequency signal.)
6. Press and hold the programmed but-
ton and check the HomeLink
light. If the indicator light stays on con-
tinuously, your garage door should acti-
vate and the programming is completed.
If the indicator light flashes rapidly for 2
seconds and then stays on continuously,
your garage door opener may be pro-
tected by a rolling code feature. In this
case you need to perform the additional
steps that are described in Programming
rolling-code-protected garage door open-
ers in the U.S.A. F3-60.
! Programming rolling-code-protected
garage door openers in the U.S.A.
If your garage door opener has a rolling
code feature, program the HomeLink
Wireless Control System for it by following
steps 1 through 5 in Garage door opener
programming in the U.S.A. F3-59. Then
continue with the following steps.
NOTE
The assistance of a second person
may make the programming quicker
and easier.
indicator
®
1. Locate the training button on the
garage door opener motor head unit.
The exact location and color of the button
may vary by brand of garage door opener.
If it is difficult to locate the training button,
refer to your garage door opener s instruc-
®