Entering The Vehicle While It Is Running Via Remote Start; Entering The Vehicle Following Remote Engine Start Shutdown; Pre-Heating Or Pre-Cooling The Interior Of The Vehicle; Service Mode (Models Without "Keyless Access With Push-Button Start System") - Subaru 2013 Legacy, 2013 Outback Owner's Manual

Owner's manual
Hide thumbs Also See for 2013 Legacy, 2013 Outback:
Table of Contents

Advertisement

& Entering the vehicle while it
is running via remote start
1. Unlock the vehicle doors using the
keyless access function (if equipped) or
remote keyless entry system. If the vehi-
cle s doors are unlocked manually using
the key, the vehicle s alarm system will
trigger (if the alarm system is armed prior
to activating the remote engine start
system) and the engine will turn off.
Perform either of the following procedures
to disarm the alarm system. Refer to
Alarm system F2-25.
. Insert the key into the ignition switch
and turn it to the ON position (models
without keyless access with push-
button start system )
. Turn the push-button ignition switch
to the Acc or ON position (models
with keyless access with push-button
start system )
. Press any button on the access key/
remote keyless entry transmitter.
2. Enter the vehicle.
3. The engine will shut down when any
door or rear gate is opened.
4. For models without keyless access
with push-button start system , insert the
key into the ignition switch and turn to the
START position to restart the engine. For
models with keyless access with push-
button start system , press the push-
button ignition switch while depressing
the brake pedal to restart the engine.
& Entering the vehicle follow-
ing remote engine start shut-
down
An alarm trigger may occur if the vehicle is
opened by the remote keyless entry
system/keyless access function within a
few seconds immediately following remote
engine start shutdown.
& Pre-heating or pre-cooling
the interior of the vehicle
Models with automatic climate control
system:
After the system starts the engine, the
automatic climate control system will
activate the FULL AUTO mode and heat
or cool the interior to the predetermined
median (room) temperature. No pre-
setting of controls is necessary.
Models without automatic climate con-
trol system:
Before exiting the vehicle, set the tem-
perature controls to the desired setting
and operation. After the system starts the
engine, the heater or air conditioning will
activate and heat or cool the interior to
Starting and operating
your setting.
& Service mode (models with-
out "keyless access with
push-button start system")
In service mode, the remote engine start
function is temporarily disabled to prevent
the system from unexpectedly starting the
engine while being serviced.
To engage or disengage service mode:
1. Enter the vehicle and close all vehicle
doors and the rear gate.
2. Verify that the select lever is in the P
position (AT and CVT models)
3. Depress and hold the brake pedal
4. Turn the ignition switch to the ON
position
5. Press and release the remote engine
start transmitter
button three times.
The system will honk the vehicle s horn
each time the button is pressed.
6. The system will pause for 1 second
then honk the vehicle s horn three times to
indicate that the service mode has been
engaged or honk one time to indicate that
the service mode has been disengaged.
NOTE
When taking your vehicle in for service,
it is recommended that you inform the
– CONTINUED –
7-17

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

LegacyOutback

Table of Contents