Removing Air Intake Duct; Pulling Off The Fender Lining; Engine Hood - Subaru 2013 Legacy, 2013 Outback Owner's Manual

& Removing air intake duct
Use a screwdriver to undo the clips on the
air intake duct, then remove the air intake
duct. Refer to Type A clips F11-5.
& Pulling off the fender lining
It is necessary to pull off the fender lining
when replacing some bulbs.
1. Start the engine and turn the steering
wheel fully in the opposite direction of the
bulb to be replaced.
2. Stop the engine.
3. Remove the clip from the fender lining.
Refer to Type B clips F11-5.
4. Pull off the fender lining.
Maintenance and service

Engine hood

To open the hood:
1. If the wiper blades are lifted off the
windshield, return them to their original
positions.
2. Pull the hood release knob under the
instrument panel.
– CONTINUED –
11-7