Setting Bluetooth Audio (Type B Audio) - Subaru 2013 Legacy, 2013 Outback Owner's Manual

entered.
2. Input the new passkey (a 4 - 8 digit
number) by operating the TUNE dial.
3. Select the CONFIRM menu.
The new passkey is displayed, the
passkey is changed and the mode
changes to the Bluetooth
setting mode.
! Deleting device
1. Select the DELETE AUDIO menu.
If no devices are registered,
EMPTY is displayed and the mode
changes to the Bluetooth
setting mode.
2. Select the CONFIRM menu.
DELETED is displayed and the
mode changes to the Bluetooth
audio setting mode.
& Setting Bluetooth
®
(type B audio)
1. Press the button to select the
BT Audio mode.
®
audio
Talk switch
®
audio
2. Press the talk switch
NOTE
If a device and a cell phone are already
®
registered, "BT" menu will be dis-
played. Then perform the following
procedure.
audio
(1) Press the talk switch
say "Setup".
(2) Press the talk switch
and say "Bluetooth audio setup".
The "BT Audio Setup" will then be
displayed.
3. After the BT Audio Setup menu is
displayed, select the following menus by
using the voice command system or by
operating the TUNE dial.
NOTE
. You cannot set Bluetooth
while driving.
. After the ignition switch is turned to
the "LOCK"/"OFF" position, the regis-
tered device/cell phone may be auto-
matically connected to the system if
the ignition switch is turned to the
"Acc" or "ON" position.
. When a cell phone is already con-
nected, the system will disconnect the
phone to setup a new device. You may
need to reconnect the phone after
setup is complete.
. Up to 2 devices (excluding cell
.
phones for Hands-free system) can be
registered.
. Up to 6 devices (including cell
phones for Hands-free system) can be
registered.
! By using voice command system
and
NOTE
again If no devices are registered, you can
only select from the following menu.
. "Pair audio player" (refer to "Regis-
tering (pairing) device" F5-42)
. "Set passkey" (refer to "Selecting
device" F5-42)
5-41
Audio
®
audio
– CONTINUED –