Subaru 2013 Legacy, 2013 Outback Owner's Manual page 280

NOTE
While the phonebook is locked, if the
operation restricted menu is selected,
"PHBK LOCK" (type A audio)/"Phone-
book locked!" (type B audio) is dis-
played.
! Unlocking the phonebook
1. Select the PHBK UNLOCK / PHONE-
BOOK UNLOCK menu.
NOTE
If the phonebook is not locked, "UN-
LOCK" (type A audio)/"The phonebook
is unlocked." (type B audio) is dis-
played and the mode changes to the
security mode.
2. Input the PIN code by performing one
of the following procedures.
Operate the TUNE dial.
Press the talk switch
the number.
3. Select the CONFIRM (type A audio)/
Confirm PIN? (type B audio) menu.
If the inputted PIN code is correct,
UNLOCKED (type A audio)/ The
phonebook is unlocked.
audio) will be displayed and the
phonebook is unlocked.
! Phone setup
After selecting the
menu, perform the following procedure.
! Pairing phone
Refer to Preparation for using the Hands-
free system F5-48.
! Selecting phone
To select the registered cell phone for
connecting to the in-vehicle equipment,
perform the following procedure.
1. Select the SELECT PHONE menu.
If no cell phones are registered,
EMPTY (type A audio)/ No Phones
have been paired. (type B audio) is
displayed and the mode changes to
the PHONE SETUP mode.
2. Select the cell phone by performing
one of the following procedures.
and say
Operate the TUNE dial.
Press the talk switch
the voice tag.
Press the talk switch
the list phones function (refer to List
phones function F5-64.)
(type B
3. Select the CONFIRM (type A audio)/
Confirm Phone selection? (type B audio)
menu (only after saying the voice tag).
SELECTED
Phone is selected. (type B audio) is
displayed, the selected cell phone is
connected to the in-vehicle equipment
PHONE SETUP
and the mode changes to the PHONE
SETUP mode.
NOTE
For type A audio, if the cell phone
cannot be connected to the in-vehicle
equipment, "FAILED" is displayed and
the mode changes to the "PHONE
SETUP" mode.
! Changing the voice tag of the cell
phone
1. Select the CHANGE NAME (type A
audio)/ Change Phone Name (type B
audio) menu.
EMPTY (type A audio)/ No Phones
have been paired. (type B audio) is
displayed and the mode changes to
the PHONE SETUP mode.
and say
2. Select the cell phone by performing
one of the following procedures.
and use
the voice tag.
the list phones function (refer to List
phones function F5-64.).
(type A audio)/
3. Register the voice tag. For details,
Audio
If no cell phones are registered,
Operate the TUNE dial.
Press the talk switch and say
Press the talk switch and use
– CONTINUED –
5-63