Channel And Category Selection; Channel Preset - Subaru 2013 Legacy, 2013 Outback Owner's Manual

5-18
Audio
& Channel and category selec-
tion
! Channel selection by operating the
dial
"TUNE" dial:
Type A audio
Type B audio
Turn the TUNE dial clockwise to select
the next channel and turn the TUNE dial
counterclockwise to select the previous
channel.
! Skip channel selection (type A
audio)
When in the SAT mode, press and hold
the following buttons to change to the
channel selection mode.
Change the channel
up by 10 channels
Change the channel
down by 10 channels
! Category selection (type B audio)
Change the cate-
gory up by one step
Change the cate-
gory down by one
step
To activate the category search mode,
press the or button. When in the
category search mode, press the
button to change the category up or
down.
When a category is selected, turning the
TUNE dial selects channels only within
the selected category.
The control function returns to the normal
mode after approximately 6 seconds.
! Channel scan (type B audio)
SCAN/A.S button
Press the SCAN/A.S button to change
the radio to the SCAN mode. In this mode,
under the selected category, the radio
scans through the channel until a station
is found. The radio will stop at the station
for 5 seconds while displaying the channel
number, after which scanning will continue
until the entire channel has been scanned.
Press the SCAN/A.S button again to
cancel the SCAN mode and to stop on any
displayed channel.
& Channel preset
! How to preset channels
1. Press the SAT button to select SAT1,
SAT2 and SAT3 reception.
2. Select the preferred channel.
or
3. Press and hold one of the preset
buttons (from to
channel. If the button is pressed briefly,
the preceding selection will remain in the
memory.
NOTE
. Up to six SAT1, SAT2 and SAT3
channels each may be preset.
. If the connection between the radio
and battery is broken for any reason
such as vehicle maintenance or radio
removal, all channels stored in the
preset buttons are cleared. If this
occurs, it is necessary to reset the
preset channels.
) to store the