Subaru 2013 Legacy, 2013 Outback Owner's Manual page 192

the ignition switch is reset (turning the
ignition switch to the ON position after
turning it to the LOCK / OFF position).
To set the display to the non-operational
mode, press and hold the power on button
for 12 to 15 seconds while the shift lever/
select lever is in the R (reverse) position,
and then release it. The display is now in
the non-operational mode. After the dis-
play has been set to the non-operational
mode, the function indicator will illuminate
in orange while the shift lever/select lever
is in the R (reverse) position.
To return the display to the operational
mode, press and hold the power on button
for 12 to 15 seconds again.
For precautions about the rear view
camera and the rear view image, refer to
Rear view camera F6-18.
! HomeLink
Wireless Control Sys-
®
tem
The HomeLink Wireless Control System
®
can be used to activate remote control
devices such as gate operators, garage
door openers, door locks, home lighting
and security systems.
There are three HomeLink buttons on the
®
mirror, each of which can be programmed
for operation of one desired device. For
details on the device types which can be
operated by this system, consult the
HomeLink website at:
®
www.homelink.com or call 1-800-355-
3515.
Note the following information about this
system.
If your vehicle is equipped with the
HomeLink Wireless Control System, it
®
complies with Part 15 of the Federal
Communications Commission Rules in
the U.S. and the RSS-210 of Industry
Canada in Canada. Its operation is subject
to the following two conditions:
(1) this device may not cause harmful
interference, and (2) this device must
accept any interference received, includ-
ing interference that may cause undesired
operation.
Changes and modifications to this system
by anyone other than an authorized
service facility could void authorization to
use this equipment.
HomeLink and the HomeLink
®
registered trademarks of Johnson Con-
trols, Inc.
WARNING
. W h e n p r o g r a m m i n g
HomeLink Wireless Control Sys-
®
tem, you may be operating a
Instruments and controls
garage door opener or other
device. Make sure that people
and objects are out of the way
of the garage door or other
device to prevent potential harm
or damage.
. Do not use the HomeLink
less Control System with a gar-
age door opener that lacks the
safety stop and reverse feature
as required by applicable safety
standards. A garage door opener
which cannot detect an object,
signaling the door to stop and
reverse, does not meet these
safety standards. Using a garage
door opener without these fea-
tures increases risk of serious
injury or death. For more infor-
mation, consult the HomeLink
website at www.homelink.com or
call 1-800-355-3515.
house are
®
When programming the HomeLink
Wireless Control System to operate
a garage door opener or an entrance
gate, unplug the device's motor
t h e
from the outlet during programming
to prevent motor burnout.
3-53
Wire-
®
®
CAUTION
®
– CONTINUED –