Assembling The Inner Rails - HP StorageWorks 2/32 - SAN Switch Installation Manual
San switch 2/32 version 4.0.x installation guide
Hide thumbs
Also See for StorageWorks 2/32 - SAN Switch:
- Installation manual (100 pages) ,
- Release note (62 pages) ,
- Administrator's manual (447 pages)
Table of Contents
Advertisement
Installing the SAN Switch 2/32
7. Assemble the two inner rails (one on each side) to the switch using (6) #8-32
Figure 11: Assembling the inner rails
8. Insert the switch with the attached inner rails into the outer rails.
9. Install the (2) remaining M5 Torx screws to complete the installation.
10. Go to the next section,
44
x 5/16 inch Phillips pan-head screws, and #8 flat washer as shown in
Figure
11.
Caution:
Do not use any screws other than the six that are provided. Use of
any longer lengths can cause damage to internal components of the switch.
Before tightening screws, make sure that the rails are centered to the overall
height of the switch.
to the switch.
Caution:
Do not connect the switch to the network until the IP address is
correctly set. For instructions on how to set the IP address, see
SAN Switch 2/32 Network
"Connecting AC
Power" for steps on applying power
Addressing," later in this chapter.
"Configuring
SAN Switch 2/32 Installation Guide
Advertisement
Table of Contents
