Connecting The Serial Cable - HP StorageWorks 2/32 - SAN Switch Installation Manual

Installing the SAN Switch 2/32
Note:
addresses with addresses provided by your Network Administrator.
1. Remove the shipping plug from the SAN Switch 2/32 Serial port.
2. Connect the Serial cable to the SAN Switch 2/32 Serial port; see
Figure 13: Connecting the Serial cable
3. Connect the other end of the Serial cable to an RS-232 Serial port on the
4. Verify that the switch power is on and POST is completed. See the
5. Power on the workstation and establish a connection to the switch using a
Note:
application, consult the specific application's documentation.
48
During first time setup, you must replace the factory IP, subnetmask and gateway
workstation. If no RS-232 Serial port is available on the workstation, the
adapter on the end of the Serial cable can be removed to use the RJ-45
connector to create a Serial connection.
Self-Test" section, earlier in this chapter.
terminal emulator application (such as Hyperterminal).
These steps show instructions specific to Hyperterminal. If using a different
Figure
SHR-2572A
"Power On
SAN Switch 2/32 Installation Guide
13.