Connecting Ac Power; Connecting The Power Cords - HP StorageWorks 2/32 - SAN Switch Installation Manual
San switch 2/32 version 4.0.x installation guide
Hide thumbs
Also See for StorageWorks 2/32 - SAN Switch:
- Installation manual (100 pages) ,
- Release note (62 pages) ,
- Administrator's manual (447 pages)
Table of Contents
Advertisement
Connecting AC Power
Use these steps to power on the SAN Switch 2/32.
1. Connect the SAN Switch 2/32 power cords to the power connectors on the
Figure 12: Connecting the power cords
2. Attach the remaining ends of the power cords to power outlets.
3. Turn on the power switch (the 1 position indicates power on, the O position
SAN Switch 2/32 Installation Guide
Caution:
Do not plug the power cords into the power source until the switch is
completely installed in the rack.
switch, see
Figure
12.
indicates power off). The switch automatically runs POST.
WARNING:
Do not connect the switch to the network until the IP address is
correctly set. For instructions on setting the IP address, see "Configuring SAN
Switch 2/32 Network Addressing," later in this chapter.
Installing the SAN Switch 2/32
SHR-2571A
45
Advertisement
Table of Contents
