Installing The Switch In The Optional Hp System/E Rack - HP StorageWorks 2/32 - SAN Switch Installation Manual

Installing the SAN Switch 2/32

Installing the Switch in the Optional HP System/e Rack

This section provides instructions for installing the SAN Switch 2/32 in the
optional HP System/e rack. The HP System/e Rack Kit consists of the following
items:
The following hardware is required to install the HP System/e Rack Mount Kit:
:
Use these steps to install the switch in the HP System/e rack.
1. Verify that all required hardware is available.
40
HP System/e Rack Rail Kit - pre-merger HP part number A7340-87901;
pre-merger Compaq part number QA-71AAA-GZ
HP System/e Rack Rail Kit Hardware - part number A7340-87902
Rails rear mounting brackets
Rail mounting hardware, shown next
(6) #8-32 x 5/16 inch Phillips pan-head screw with captive star
lock washer
(6) #8 Flat washer
(6) M5 Torx head screw with captive lock washer
(2) Rubber washer
(4) M5 U-type Tinnerman clip
Caution: For proper airflow, the SFP media side of the SAN Switch 2/32
faces the rear of the rack. This mounting allows air to enter from the front of the
rack and to exhaust at the rear of the rack, similar to other rack-mounted
equipment. This prevents switch overheating, which may cause it to fail.
SAN Switch 2/32 Installation Guide