HP StorageWorks 2/32 - SAN Switch Installation Manual page 49

6. Using Hyperterminal (or similar application), configure the port settings as
7. Login to the switch (with administrative privileges). The default
SAN Switch 2/32 Installation Guide
follows:
Bits per second: 9600
Databits: 8
Parity: None
Stop bits: 1
Flow control: None
To configure port settings in a UNIX environment, type:
tip /dev/ttyb -9600
administrative logon is admin and the default password is password.
a. Enter the following at the prompt:
ipAddrSet
b. Enter the following information at the corresponding prompts, as in the
example below:
Example
switch:admin> ipaddrset
Ethernet IP Address [10.77.77.77]:10.32.53.47
Ethernet Subnetmask [255.0.0.0]:255.255.240.0
Fibre Channel IP Address [0.0.0.0]:
Fibre Channel Subnetmask [0.0.0.0]:
Gateway IP Address [
Set IP address now? [y = set now, n = next
reboot]:y
IP address being changed...
Committing configuration...Done.
switch:admin>
c. To verify that the IP address was entered correctly, type:
ipAddrShow
d. Once the IP address is verified as correct, remove the Serial cable, and
replace the shipping plug in the Serial port.
0.0.0.0
]:10.32.48.1
Installing the SAN Switch 2/32
49