Attaching The Rear Or Front Rack Mount Brackets; For Rear Rack Access; Attaching The Rear Rack Mount Brackets - HP StorageWorks 2/32 - SAN Switch Installation Manual

Installing the SAN Switch 2/32

Attaching the Rear or Front Rack Mount Brackets

The Rack Mount Kit supplied with the SAN Switch 2/32 contains two rear rack
mount brackets and two front rack mount brackets. Install these rack mount
brackets to prevent the switch from accidentally sliding out of the rack, as follows.

For Rear Rack Access

Use these steps to attach the rear rack mount brackets to the switch. The rear rack
mount brackets act as "stops" to prevent the switch from sliding out the rear of the
rack. Use these steps if you installed the inner slide rails to the switch using the
procedure outlined in
1. Align the right rack mount bracket with the two screw holes at the port end of
2. Locate two Phillips head 8-32 x 3/16 inch screws, contained in the Rack
Figure 5: Attaching the rear rack mount brackets
34
Caution: HP recommends installing the SAN Switch 2/32 so that the port side
of the switch slides out the rear of the rack. (For example, the switch should
face the aisle where exhaust air is released. Air intake and exhaust for all
components in the rack should flow in the same direction.)
"Attaching the Inner Slide Rails to the
the switch.
Mount Kit. Secure the right mount bracket to the switch; see
Switch," step 1a.
Figure
SHR-2576A
SAN Switch 2/32 Installation Guide
5.