Configuring Common Settings For Console Login (Optional) - HP 5800 Series Configuration Manual

Configuring common settings for console login (optional)

CAUTION:
The common settings configured for console login take effect immediately. If you configure the common
settings after you log in through the console port, the current connection may be interrupted, so you should
use another login method. After you configure common settings for console login, you must modify the
settings on the terminal to make them consistent with those on the device.
Step
1. Enter system view.
2. Enable display of copyright
information.
3. Enter AUX user interface view.
4. Configure
AUX user
interface
view
properties.
Command
system-view
copyright-info enable
user-interface aux
first-number
[ last-number ]
Configure baud
speed speed-value
rate.
Configure parity parity { even | mark |
check mode. none | odd | space }
Configure stop
stopbits { 1 | 1.5 | 2 }
bits.
Configure data databits { 5 | 6 | 7 |
bits. 8 }
Define shortcut
key for enabling activation-key
a terminal character
session.
Define shortcut
key for escape-key { default |
terminating character }
tasks.
Remarks
—
Optional.
Enabled by default.
—
Optional.
By default, the transmission rate is 9600 bps.
Transmission rate is the number of bits that the
device transmits to the terminal per second.
Optional.
none by default.
Optional.
By default, the stop bit of the console port is 1.
Stop bits are the last bits transmitted in data
transmission to unequivocally indicate the end
of a character. The more the bits are, the
slower the transmission is.
Optional.
By default, the data bit of the console port is 8.
Data bits is the number of bits representing
one character. The setting depends on the
contexts to be transmitted. For example, set it
to 7 if standard ASCII characters are to be
sent, and set it to 8 if extended ASCII
characters are to be sent.
Optional.
By default, press Enter to enable a terminal
session.
Optional.
By default, press Ctrl+C to terminate a task.
35