HP StorageWorks 2/32 - SAN Switch Installation Manual page 36

Installing the SAN Switch 2/32
Note:
preinstalled at the end of each outer slide rail; see Figure 6. The L-brackets are
necessary to attach the outer rails to the rack.
1. Determine the appropriate placement for the switch inside the rack. The HP
Note:
2. Locate the small, round marker hole on the rack's rails, which coincides with
3. Insert one square alignment washer on each of the
Note:
4. Adjust the outer slide rail's length to fit the length of the rack.
5. Position one of the outer slide rails in the rack, as described below:
6. Holding the outer slide rail in place, insert one 3-hole bar nut in between the
Note:
screws, as described in step 3. The square alignment washers are mandatory for
proper switch alignment.
36
Before starting this procedure, verify that two of the slide mount L-brackets are
9000 Series Rack's rails are divided into Units (Us). Each U is marked with a
small, round hole and three square openings for mounting equipment.
The SAN Switch 2/32 requires 1.5 Units of rack space.
the location selected in step 1. Each marker hole delineates the beginning of
one U.
head screws.
The square alignment washers are mandatory for proper switch alignment.
a. To allow the switch's port end to slide out the back of the rack, orient with
the closed end of the outer slide rail towards the front of the rack.
b. To allow the power supply end to slide out the front of the rack, orient the
closed end of the outer slide rail towards the back of the rack.
rack's rail and the L-bracket at the end of the outer slide rail,
Position the square alignment washers onto the Phillips head 10-32 x 3/8 inch
eight 10-32 x 3/8 inch Phillips
Figure
SAN Switch 2/32 Installation Guide
6.