Installing The Rubber Washers - HP StorageWorks 2/32 - SAN Switch Installation Manual

I
[1] Select this graphic frame.
[2] Select File.
[3] Select Import.
[4] Select File.
[5] Choose the appropriate graphic file name.
[6] Make sure you've checked the Copy Into Document.
[7] Select Import. Position the illustration as required.
[8] Adjust the size of the outer graphic frame as required.
Delete this set of instructions
Rubber washer (1 of 2)
1
Figure 10: Installing the rubber washers
6. Install(1) M5 Torx screw in the upper hole location of the right rail. Then,
Note:
SAN Switch 2/32 Installation Guide
Rear rail tray bracket (1 of 2)
2
install (1) M5 Torx screw in the lower location of the left rail. See
Do not install the upper left and the lower right screws until step 9.
Installing the SAN Switch 2/32
1
2
SHR-2559A
Figure 11.
43