Configuring Common Console Login Settings (Optional) - HP 6125G Configuration Manual

Step
9. Set an authentication
password for the local user.
10. Specifies a command level
of the local user.
11. Specify terminal service for
the local user.
12. Configure common settings
for console login.
The next time you attempt to log in through the console port, you must provide the configured login
username and password, as shown in
Figure 11 Scheme authentication interface for console login

Configuring common console login settings (optional)

Some common settings configured for an AUX user interface take effect immediately and can interrupt
the console login session. To save you the trouble of repeated re-logins, use a login method different from
console login to log in to the device before you change console login settings.
After the configuration is complete, change the terminal settings on the configuration terminal and make
sure they are the same as the settings on the device.
To configure common settings for an AUX user interface:
Step
1. Enter system view.
2. Enable copyright information
display.
Command
password { cipher | simple }
password
authorization-attribute level level
service-type terminal
See "Configuring common console
login settings (optional)."
Figure 1 1.
Command
system-view
copyright-info enable
30
Remarks
By default, no password is set.
Optional.
By default, the command level is 0.
By default, no service type is
specified.
Optional.
Remarks
N/A
By default, copyright information
display is enabled.