Installing the SAN Switch 2/32
9. Repeat steps 5 through 7 to secure the other end of the outer slide rail.
10. Repeat steps 3 through 7 to install the second outer slide rail.
Finalizing the Rack Mounting Procedure
Read this section to finalize the rack mount procedure.
Positioning the Switch in the HP 9000 Series Rack
Follow these steps to install the switch in the rack.
Note:
3U space), you must mount the slide rails attached to the switch using the set of holes
on the top of the switch, and the bottom using the set of holes on the bottom of the
switch.
1. Depending on the type of install (front or rear access), slide the outer slide
2. Carefully lift the switch into the rear of the rack, inserting the inner slide rails
3. Slide the switch into the rack; see
38
If installing more than one SAN Switch 2/32 directly on top of one another (in a
rails all the way toward the front or back of the rack.
(attached to the switch) into the outer slide rails (attached to the rack).
Figure
7.
SAN Switch 2/32 Installation Guide