Restoring The System Configuration Settings - HP StorageWorks 2/32 - SAN Switch Installation Manual

Restoring the System Configuration Settings

Use these steps to restore the system configuration settings from a backup.
1. Verify that the RSHD service or the FTP service is running on the host
2. Login to the switch as the admin user.
3. Shut down the switch by entering the following command:
4. At the command line, enter the following command:
For example, hostIPaddr is the IP address of the host computer, user is the User
ID used to log into this computer, path_filename is the path location and filename
of the configuration file, and password is the password for the user ID specified.
5. Reboot the switch, type:
SAN Switch 2/32 Installation Guide
workstation.
switchDisable
configdownload hostIPaddr,user,path_filename,password
The password operand is only required if you are using FTP.
fastBoot
Backing Up the Configuration and Upgrading Firmware
81