7. Secure each L-bracket and 3-hole bar nut to the rack's rails with two Phillips
.
1
1
2
3
Figure 6: Attaching the outer slide rails to the HP 9000 Series rack
Note:
8. Tighten the screws, and torque to 25 inch-pounds.
SAN Switch 2/32 Installation Guide
head 10-32 x 3/8 inch screws (and attached square alignment washers); see
Figure
6.
[1] Select this graphic frame.
[2] Select File.
[3] Select Import.
[4] Select File.
[5] Choose the appropriate graphic file name.
[6] Make sure you've checked the Copy Into Document.
[7] Select Import. Position the illustration as required.
[8] Adjust the size of the outer graphic frame as required.
2
Delete this set of instructions
Phillips head 10-32 x 3/8 in screw
3-hole bar nut
Outer slide rail
Remember to position the 3-hole bar nut behind the L-bracket.
3
4
5
Installing the SAN Switch 2/32
4
5
SHR-2478A
L-Brackets
Power cord clip (1 of 6)
37