Installing The Rubber Washers - HP StorageWorks SAN Switch 2/32 Installation Manual

I
[1] Select this graphic frame.
[2] Select File.
[3] Select Import.
[4] Select File.
[5] Choose the appropriate graphic file name.
[6] Make sure you've checked the Copy Into Document.
[7] Select Import. Position the illustration as required.
[8] Adjust the size of the outer graphic frame as required.
Delete this set of instructions
1
Rubber washer (1 of 2)
Figure 2–8: Installing the rubber washers
6. Install one M5 Torx screw in the upper hole location of the right rail. Then, install
one M5 Torx screw in the lower location of the left rail. See Figure 2–9.
NOTE: Do not install the upper left and the lower right screws until step 9.
SAN switch 2/32 version 4.0.x installation guide
2
Rear rail tray bracket (1 of 2)
Installing the SAN Switch 2/32
1
2
SHR-2559A
2–19 2–19