Installing The Rubber Washers - HP StorageWorks 2/8-EL - SAN Switch Installation Manual

I
[1] Select this graphic frame.
[2] Select File.
[3] Select Import.
[4] Select File.
[5] Choose the appropriate graphic file name.
[6] Make sure you've checked the Copy Into Document.
[7] Select Import. Position the illustration as required.
[8] Adjust the size of the outer graphic frame as required.
Delete this set of instructions
Rubber washer (1 of 2)
1
Figure 10: Installing the rubber washers
Note:
SAN Switch 2/8 Version 3.1.x Installation Guide
b. Insert the alignment pins attached to the outer rail front flange into the
center opening in the rack.
c. Install one M5 Torx screw in the upper hole location of the right rail.
Then, install one M5 Torx screw in the lower location of the left rail. See
Figure 11.
Do not install the upper left and lower right screws until later.
Rear rail tray bracket (1 of 2)
2
Installing the SAN Switch 2/8
1
2
SHR-2559A
41