Dell PowerConnect 5548P System User's Manual page 673

FILE LOCATION: C:\Users\gina\Desktop\Checkout_new\Maintenance Projects\Dell
2 Enter the fields:
– Trust Mode — Enable/disable Trust mode.
• CoS — Traffic is mapped to queues, based on the VPT field in the
VLAN tag, or based on the per-port default CoS value (if there is
no VLAN tag on the incoming packet). The mapping of the VPT
to queue can be configured in the CoS to Queue page.
DSCP — All IP traffic is mapped to queues, based on the DSCP
•
field in the IP header. The mapping of the DSCP to queue is
configured in the DSCP to Queue page.
– Always Rewrite DSCP — Check to always rewrite the DSCP values in
the incoming packets with the new values set in the DSCP to Queue
page. When this field is enabled, the switch uses the new DSCP
values to select the egress queue.
Assigning Global Settings Using CLI Commands
The following table summarizes the CLI commands for configuring fields in
the Global Settings page.
Table 22-8. Global Settings CLI Commands
CLI Command
qos trust {cos|dscp}
no qos trust
qos dscp-mutation
no qos dscp-mutation
The following is an example of the CLI commands:
console(config)# qos trust dscp
console(config)# qos dscp-mutation
D E L L C O N F I D E N T I A L – P R E L I M I N A R Y 9 / 1 1 / 1 2 - F O R P R O O F O N LY
672
Dell PowerConnect 55xx Systems User Guide
Contax\CxUGQoS.fm
Description
Configures the system to either the
CoS or DSCP trust state.
Use the no form of this command to
return to the default configuration.
Applies the DSCP Mutation map to
system DSCP trusted ports.
Use the no form of this command to
restore the trusted port with no
DSCP mutation.