Dell PowerConnect 5548P System User's Manual page 479

FILE LOCATION: C:\Users\gina\Desktop\Checkout_new\Maintenance Projects\Dell
Frame Type — Select the packet type accepted on the port. The
–
possible options are:
• Admit All — Both tagged and untagged packets are accepted on
the port.
• Admit Tagged Only — Only tagged packets are accepted on the
port.
Admit Untagged Only — Only untagged packets are accepted on
•
the port.
– Ingress Filtering — Enable/disable ingress filtering, which discards
packets that are destined to VLANs of which the specific port is not a
member.
– Native VLAN ID(1-4094) — Enter VLAN used for untagged traffic to
trunk ports.
– Multicast VLAN ID(1-4094) — Enter VLAN used for Multicast TV
VLAN traffic on access ports.
– Customer VLAN ID(1-4094) — Enter VLAN used for customer
ports.
Assigning Ports to VLAN Groups Using CLI Commands
The following table summarizes the CLI commands for assigning ports to
VLAN groups.
Table 14-2. Port-to-VLAN Group Assignments CLI Commands
CLI Command
switchport general acceptable-
frame-type {tagged-only|untagged-
only|all}
no switchport general acceptable-
frame-type
switchport mode
{access|trunk|general}
D E L L C O N F I D E N T I A L – P R E L I M I N A R Y 9 / 1 1 / 1 2 - F O R P R O O F O N LY
478
Dell PowerConnect 55xx Systems User Guide
Contax\CxUGSwitching_VLAN.fm
Description
Configures ingress filtering based
on packet type tagged/untagged.
Use the no form of this command
to return to default.
Configures the VLAN
membership mode of a port.