Cf_Shuteffect Command; Cf_Shutrelease Command; Cf_Delayctrl Command; Cf_Ccaptiondisp Command - Sanyo PLC-HF15000L - 15000 Lumens Manual

PLC-HF15000L Expand Serial Command Functional Specifications

8.9.54 CF_SHUTEFFECT Command

Command "CF_SHUTEFFECT_%1" [CR]
"OFF" --------Disable fade in and out function of Shutter
%1 "L1" --------- Set fade in and out function of Shutter to L1
"L2" --------- Set fade in and out function of Shutter to L2
Set Effect function of Shutter. (Valid only when in the normal Power ON status)
When L1 is selected, projected image quickly fade in and out
Details
When L2 is selected, projected image slowly fade in and out.
The status set by this command is stored in EEPROM and setting remains
effective even after the power is turned to ALL OFF status.
Acceptable
Response
Unacceptable

8.9.55 CF_SHUTRELEASE Command

Command "CF_SHUTRELEASE_%1" [CR]
"ANY"----------------------------Enable to release Shutter with any key
%1
"SHUTTER" ------------------ Enable to release Shutter with only "SHUTTER" key
Set Release key of Shutter. (Valid only when in the normal Power ON status)
Details The status set by this command is stored in EEPROM and setting remains
effective even after the power is turned to ALL OFF status.
Acceptable
Response
Unacceptable

8.9.56 CF_DELAYCTRL Command

Command "CF_DELAYCTRL_%1" [CR]
"OFF"---------- Set Video delay control to OFF
"LOW"---------- Set Video delay control to LOW
%1
"MID"----------- Set Video delay control to MID
"HIGH"---------- Set Video delay control to HIGH
Select the mode of Video delay control
(Valid only when in the normal Power ON status)
Details
The status set by this command is stored in EEPROM and setting remains
effective even after the power is turned to ALL OFF status.
Acceptable
Response
Unacceptable

8.9.57 CF_CCAPTIONDISP Command

Command "CF_CCAPTIONDISP_%1" [CR]
"OFF" ------------- Select Off
"CC1" ------------- Select CC1
%1 "CC2" ------------- Select CC2
"CC3" ------------- Select CC3
"CC4" ------------- Select CC4
Select channel of Closed caption.
The status set with this command is stored in EEPROM and its setting is effective
even after ALL is OFF. This command is available in normal Power ON status.
Details
Note) Closed caption is available under conditions below;
Entered signal is appropriate (NTSC signal from Video or S-video) or System is
fixed to NTSC.
Acceptable
Response
Unacceptable
"000" [CR]
"Error Code" [CR]
"000" [CR]
"Error Code" [CR]
"000" [CR]
"Error Code" [CR]
"000" [CR]
"Error Code" [CR]
58/105
.