PLC-HF15000L Expand Serial Command Functional Specifications
8.5.4 CF_V-POS Command
Command
"CF_V-POS_%1" [CR]
"0000-nnnn" ------------ Directly specify setting value of Vertical Position
%1
"UP" --------------------- Increment setting value of Vertical Position by 1
"DN" --------------------- Decrement setting value of Vertical Position by 1
Set Vertical Position value in PC signal (Available only in the normal Power ON
status)
Details
The value set by this command is not stored in the projector's memory.
Therefore, when the power is turned to ALL OFF status, the value returns to the
original setting. (It is stored in Suspend mode.)
Acceptable
Response
Unacceptable
8.5.5 CF_CLAMP Command
Command
"CF_CLAMP_%1" [CR]
"0000-4095" ----------- Directly specify setting value of Clamp
%1
"UP" --------------------- Increment setting value of Clamp by 1
"DN" --------------------- Decrement setting value of Clamp by 1
Set Clamp value in PC signal. (Available only in the normal Power ON status)
The value set by this command will not be stored in the projector's memory.
Details
Therefore, when the power is turned to ALL OFF stasis, the value returns to the
original setting. (It is stored in Suspend mode.)
Acceptable
Response
Unacceptable
8.5.6 CF_DDOTS Command
Command
"CF_DDOTS_%1" [CR]
"0256-nnnn" ----------------- Directly specify setting value of Display Dots
%1
"UP" ------------------- Increment setting value of Display Dots by 2
"DN" ------------------- Decrement setting value of Display Dots by 2
Set Display Dots value in PC signal. (Available only in the normal Power ON
status)
Details
The value set by this command is not stored in the projector's memory. Therefore,
when the power is turned to ALL OFF status, the value returns to the original
setting. (It is stored in Suspend mode.)
Acceptable
Response
Unacceptable
"nnnn" indicates maximum value, which is current (Total Line – Display Area V) value
"000" [CR]
"101" [CR] --- When input is Video signal
--- When input is no signal
"000" [CR]
"101" [CR] --- When input is Video signal
"nnnn" indicates maximum value, which is current value of (Total Dots - Position H).
In this projector, the value should be "even number" and if "odd number" is specified,
it adds 1 to make the value even number.
"000" [CR]
"101" [CR] --- When input is Video signal
29/105
--- When input is no signal
--- When input is no signal