Cf_Pjpincode Command; Cf_Shutrcprot Command; Cf_Shutkeyprot Command; Cf_Shuth Command - Sanyo PLC-HF15000L - 15000 Lumens Manual

PLC-HF15000L Expand Serial Command Functional Specifications

8.9.50 CF_PJPINCODE Command

Command "CF_PJPINCODE_%1" [CR]
%1 "0000 – 9999" ------------- Directly specify PJ PIN code
Enter PIN code to cancel PIN code lock
(Available only in the normal Power ON status)
PIN code can not be changed. (Only PIN code lock is canceled.)
*When PIN code Lock is enabled:
PIN code is matched ------------------------- Command is valid (Acceptable)
PIN code is mismatched -------------------- Command is invalid (Error code "102")
PIN code is beyond %1 available range ----- Command is invalid (Error code "?")
Details
When PIN code lock is canceled:
PIN code is within %1 range ----------- Command is valid (Acceptable)
PIN code is out of %1 range ----------- Command is invalid (Error code is "?")
This command is only valid when "PJ PIN code" dialog is displayed to enter PIN
code after Power is ON and Countdown is completed.
When PIN code lock is set to "On1", it needs to send this command every time the
projector is turned on.
Acceptable
Response
Unacceptable

8.9.51 CF_SHUTRCPROT Command

Command "CF_SHUTRCPROT_%1" [CR]
"ON" ------------------ Disable RC key from controlling Shutter (Protection On)
%1
"OFF" ----------------- Enable RC key to control Shutter (Protection Off)
Set valid / invalid of RC use on Shutter control function
Details
(Valid only when in the normal Power ON status)
Acceptable
Response
Unacceptable

8.9.52 CF_SHUTKEYPROT Command

Command "CF_SHUTKEYPROT_%1" [CR]
"ON" --------- Disable key on the side panel from controlling Shutter (Protection On)
%1
"OFF" -------- Enable key on the side panel to control Shutter (Protection Off)
Set valid / invalid use of key on the top panel on Shutter control function.
Details
(Valid only when in the normal Power ON status)
Acceptable
Response
Unacceptable

8.9.53 CF_SHUTH Command

Command "CF_SHUTH_%1" [CR]
"005"-"480"----------Specify setting time directly
%1 "UP" ------------------ Add 1 minute
"DN" ------------------Decrease 1 minute
Set time of operating shutter management function.
(Valid only when in the normal Power ON status)
Details
The status set by this command is stored in EEPROM and setting remains
effective even after the power is turned to ALL OFF status.
Acceptable
Response
Unacceptable
"000" [CR]
"Error Code" [CR]
"000" [CR]
"Error Code" [CR]
"000" [CR]
"Error Code" [CR]
"000" [CR]
"Error Code" [CR]
57/105