Configuring Wireless Settings - NETGEAR WG302 - 802.11g ProSafe Wireless Access Point Reference Manual

NETGEAR ProSafe 802.11g Wireless Access Point WG302 Reference Manual
– Default Gateway: Enter the IP address of your LAN Gateway. For more complex
networks, enter the address of the router for the network segment to which the wireless
access point is connected. The default is 0.0.0.0.
– Primary and Secondary DNS Servers: Enter the IP address of the Domain Name Server
(DNS) you wish to use. The default is 0.0.0.0.
4. Spanning Tree Protocol. Enable or disable spanning tree protocol. Spanning tree protocol
provides network traffic optimization in settings with multiple ProSafe 802.11gs. The default
is Enabled.
5. Enable 802.1Q VLAN. Check the radio box to accept 802.1Q VLAN to allow the WG302 to
process VLAN membership. The default is disabled.
6. From the pull-down men, select the local Time Zone setting for your location.
7. Check the Adjust for Daylight Saving Time if your location uses daylight saving. The
default is no adjustment.
Note: You must have an Internet connection to get the current time.
8. Click Apply so save your Basic IP settings.

Configuring Wireless Settings

To configure the wireless settings of your wireless access point:
1. Click Wireless Settings under Setup in the main menu of the browser interface. The Basic
Wireless Settings menu will appear, as shown below.
Basic Installation and Configuration
v4.0, April 2006
2-11