Configuring Your Wireless Settings - NETGEAR WN802T - RangeMax Next Wireless Access Point User Manual

– Default Gateway. Enter the IP address of the gateway for your LAN. For more complex
networks, enter the address of the router for the network segment to which the wireless
access point is connected. The default is 0.0.0.0.
– Primary DNS Servers. The WN802T will use this IP address as the primary Domain
Name Server used by stations on your LAN. The default is 0.0.0.0.
– Secondary DNS Servers. The WN802T will use this IP address as the secondary Domain
Name Server used by stations on your LAN. The default is 0.0.0.0.
4. From the pull-down menu, select the local Time Zone for your wireless access point from a
list of all available time zones. The default is GMT.-08:00
5. Check the Adjust for Daylight Saving Time if your location uses daylight savings. The
default is no adjustment.
Note: If you do not have an Internet connection to get the current time, the wireless
access point will get the current time from the connecting PC.
6. Click Apply to save your Basic IP settings.
Note: If you change the default subnet of the LAN IP address, you will be
disconnected from the RangeMax NEXT user interface. To reconnect,
reconfigure your computer with a static IP address within the new LAN IP
subnet.
By default, the WN802T is set with the DHCP client disabled. If your network uses dynamic IP
addresses, you must change this setting (see

Configuring Your Wireless Settings

The following sections describe how to configure the wireless settings for both the 802.11b/g/Next
and 802.11b/g modes.
To configure the RangeMax NEXT wireless settings of your wireless access point:
1. From the main menu under Setup, select Wireless Settings.The Wireless Settings screen will
display as shown in
Installation and Configuration
RangeMax NEXT Wireless-N Access Point WN802T Reference Manual
"Logging in to the RangeMax NEXT" on page
Figure 2-4 below
v1.0, August 2007
2-12),
2-7