NETGEAR WG302 - 802.11g ProSafe Wireless Access Point Reference Manual page 34

NETGEAR ProSafe 802.11g Wireless Access Point WG302 Reference Manual
Figure 2-7.
2. Enter the wireless access point name of the WG302:
This unique name is the access point NetBIOS name. The default Access Point Name is
located on the bottom label of WG302. The default is netgearxxxxxx, where xxxxxxx
represents the last 6 digits of the WG302 MAC address. You may modify the default name
with a unique name up to 15 characters long.
3. Enter the IP Address fields of the WG302:
– DHCP Client. By default, the Dynamic Host Configuration Protocol (DHCP) client is
disabled. If you have a DHCP server on your LAN and you enable DHCP, the wireless
access point will get its IP address, subnet mask and default gateway settings
automatically from the DHCP server on your network when you connect the WG302 to
your LAN.
– IP Address: The default IP address is 192.168.0.228. If you want to change it, enter an
unused IP address from the address range used on your LAN; or enable DHCP.
– IP Subnet Mask: Enter the subnet mask value used on your LAN. The default is
255.255.255.0.
2-10 Basic Installation and Configuration
v4.0, April 2006