Step 3: Deploy The Prosafe 802.11G - NETGEAR WG302 - 802.11g ProSafe Wireless Access Point Reference Manual

NETGEAR ProSafe 802.11g Wireless Access Point WG302 Reference Manual
Rest of World
Figure 2-4.
7. Configure the wireless interface for wireless access. See the online help or
Wireless Settings" on page 2-11
Note: You must set the Regulatory Domain. It may not be legal to operate the
wireless access point in a region other than one of those identified in this field.
Now that you have finished the setup steps, you are ready to deploy the WG302 in your
network. If needed, you can now reconfigure the computer you used in step 1 back to its
original TCP/IP settings.

Step 3: Deploy the ProSafe 802.11g

1. Disconnect the WG302 and position it where you will deploy it. The best location is elevated,
such as wall mounted or on the top of a cubicle, at the center of your wireless coverage area,
and within line of sight of all the mobile devices.
2. Lift the antenna on either side so that they are vertical.
Note: Consult the antenna positioning and wireless mode configuration information
in "Advanced Configuration" on page 4-1
3. Connect an Ethernet cable from your ProSafe 802.11g to a LAN port on your router, switch, or
hub.
Basic Installation and Configuration
of this Reference Manual for full instructions.
v4.0, April 2006
United States
"Configuring
of the Reference Manual.
2-7