NETGEAR WG302 - 802.11g ProSafe Wireless Access Point Reference Manual page 56

NETGEAR ProSafe 802.11g Wireless Access Point WG302 Reference Manual
Figure 2-19.
4. From the Select Access Control Database pull-down menu, choose the local MAC address
database stored on the access point, or use the RADIUS MAC address database stored on a
RADIUS server. If you choose the RADIUS MAC Address Database, you must configure the
RADIUS Server Settings first (see
page 2-21). The default is the Local MAC Address Database.
5. Select the stations from the list of Available Wireless Stations found in your area, or enter the
MAC address in Add New Station Manually. (You can usually find the MAC address printed
on the bottom of the wireless adapter.)
6. Click Add to add the wireless device to the Trusted Wireless Stations list. Repeat these steps
for each additional device you want to add to the list.
7. Click Apply to save your wireless access control list settings.
Note: If configuring the WG302 from a wireless computer whose MAC address is not in
the Access Control list, when you select Turn Access Control On, you will lose
your wireless connection when you click Apply. You must then access the wireless
access point from a wired computer or from a wireless computer which is listed in
the Access Control list to make any further changes.
2-32
"Configuring RADIUS Server Settings (if required)" on
v4.0, April 2006
Basic Installation and Configuration