NETGEAR WG302 - 802.11g ProSafe Wireless Access Point Reference Manual page 88

NETGEAR ProSafe 802.11g Wireless Access Point WG302 Reference Manual
Table A-1. Access Point Default Configuration Settings
Feature
Time Zone Adjusted for Daylight Saving
Time
SNMP
Spanning Tree Protocol
Secure Telnet
Wireless
Operating Mode
Access Point Name
Wireless Communication
Wireless Network Name (SSID)
Broadcast Network Name SSID
Security
Transmission Speed
Country/Region
80211.g Radio Frequency Channel
VLAN(802.1Q)
Output Power
Wireless Card Access List
WMM Support
SuperG Mode
a. Maximum Wireless signal rate derived from IEEE Standard 802.11 specifications. Actual throughput will
vary. Network conditions and environmental factors, including volume of network traffic, building materials
and construction, and network overhead, lower actual data throughput rate.
A-2
Description
Disabled
Enabled, but Trap forwarding disabled
Enabled
Enabled
Access Point
netgearxxxxxx where xxxxxx are the last 6 digits of the
wireless access point MAC address.
Enabled
NETGEAR
Enabled
Disabled
Auto
a
United States (in North America; otherwise, varies by
region)
11 until the region is selected
Disabled
Full
All wireless stations allowed
Disabled
Disabled
Factory Defaults and Technical Specifications
v4.0, April 2006