NETGEAR WG302 - 802.11g ProSafe Wireless Access Point Reference Manual page 82

NETGEAR ProSafe 802.11g Wireless Access Point WG302 Reference Manual
• All APs must be on the same LAN. That is, all the APs LAN IP address must be in the
same network.
• If using DHCP, all ProSafe 802.11gs should be set to "Obtain an IP address automatically
(DHCP Client)" in the IP Address Source portion of the Basic IP Settings menu.
• All ProSafe 802.11gs use the same SSID, Channel, authentication mode, if any, and
encryption in use.
4. Verify connectivity across the LANs.
A computer on any LAN segment should be able to connect to the Internet or share files and
printers with any other PCs or servers connected to any of the three WLAN segments.
5. Click Apply.
Note: You can extend this repeating by adding up to 2 additional WG302s configured
in repeater mode. However, since Repeater configurations communicate in
half-duplex mode, the bandwidth decreases as you add Repeaters to the
network. Also, you can extend the range of the wireless network with
NETGEAR wireless antenna accessories
4-10
v4.0, April 2006
Advanced Configuration