Applying A Qos Profile - 3Com 5500-EI PWR Install Manual

To do...
Configure packet
filtering
Configure priority
marking

Applying a QoS Profile

You can configure to apply a QoS profile dynamically or simply apply a QoS profile
manually.
Configuration prerequisites
To configure to apply a QoS profile dynamically, make sure 802.1x is enabled both
globally and on the port, and the authentication mode is determined. For information
about 802.1x, refer to the 802.1x and System Guard module of this manual.
To apply a QoS profile manually, make sure the port to which the QoS profile is to be
applied is determined.
The QoS profile to be applied is determined.
Configuration procedure
Follow these steps to configure to apply a QoS profile dynamically:
Enter system view
Enter Ethernet port view
Use the command...
packet-filter { inbound |
outbound } acl-rule
traffic-priority { inbound |
outbound } acl-rule { { dscp
dscp-value | ip-precedence
{ pre-value | from-cos } } | cos
{ pre-value | from-ipprec } |
local-precedence pre-value }*
To do... Use the command...
system-view
interface
interface-type
interface-number
2-3
Remarks
Optional
Refer to the ACL module of
this manual for information
about packet filtering.
Optional
Remarks
—
—