Habp Client Configuration; Displaying And Maintaining Habp Configuration - 3Com 5500-EI PWR Install Manual

Configure the current switch
to be an HABP server
Configure the interval to send
HABP request packets.

HABP Client Configuration

HABP clients reside on switches attached to HABP servers. After you enable HABP for a switch, the
switch operates as an HABP client by default. So you only need to enable HABP on a switch to make it
an HABP client.
Follow these steps to configure an HABP client:
To do...
Enter system view
Enable HABP

Displaying and Maintaining HABP Configuration

To do...
Display HABP configuration
and status
Display the MAC address table
maintained by HABP
Display statistics on HABP
packets
habp server vlan vlan-id
habp timer interval
Use the command...
system-view
habp enable
Use the command...
display habp
display habp table
display habp traffic
3-2
Required
By default, a switch operates
as an HABP client after you
enable HABP on the switch. If
you want to use the switch as a
management switch, you need
to configure the switch to be an
HABP server.
Optional
The default interval for an
HABP server to send HABP
request packets is 20 seconds.
Remarks
—
Optional
HABP is enabled by default.
And a switch operates as an
HABP client after you enable
HABP for it.
Remarks
Available in any view
Available in any view
Available in any view