3Com 5500-EI PWR Install Manual page 995

To do...
Configure the probe timeout
time
Configure the type of service
Start the test
Display test results
7) Configuring TCP test on remote-ping client
Follow these steps to configure TCP test on remote-ping client:
To do...
Enter system view
Enable the remote-ping
client function
Create a remote-ping
test group and enter its
view
Configure the destination
address
Configure the destination
port
Configure the source IP
address
Configure the source
port
Configure the test type
Use the command...
timeout time
tos value
test-enable
display remote-ping results
[ admin-name operation-tag ]
Use the command...
system-view
remote-ping-agent enable
remote-ping
administrator-name
operation- tag
destination-ip ip-address
destination-port
port-number
source-ip ip-address
source-port port-number
test-type { tcpprivate |
tcppublic }
1-16
Remarks
Optional
By default, a probe times out in
three seconds.
Optional
By default, the service type is
zero.
Required
Required
You can execute the command
in any view.
Remarks
—
Required
By default, the remote-ping client
function is disabled.
Required
By default, no test group is configured.
Required
This IP address and the one configured
on the remote-ping server for listening
services must be the same.
By default, no destination address is
configured.
Required in a Tcpprivate test
A Tcppublic test is a TCP connection
test on port 7. Use the
remote-ping-server tcpconnect
ip-address 7 command on the server to
configure the listening service port;
otherwise the test will fail. No port
number needs to be configured on the
client; any destination port number
configured on the client will not take
effect.
By default, no destination port number is
configured.
Optional
By default, the source IP address is not
specified.
Optional
By default, no source port is specified.
Required
By default, the test type is ICMP.