3Com 5500-EI PWR Install Manual page 272

Figure 2-1 Network diagram for static route configuration
1.1.2.2/24
1.1.1.1/24
Switch A
1.1.1.2/24
Host C
Configuration procedure
When only one interface of the device is interconnected with another network segment, you can
implement network communication by configuring either a static route or default route.
1) Perform the following configurations on the switch.
# Approach 1: Configure static routes on Switch A.
<SwitchA> system-view
[SwitchA] ip route-static 1.1.3.0 255.255.255.0 1.1.2.2
[SwitchA] ip route-static 1.1.4.0 255.255.255.0 1.1.2.2
[SwitchA] ip route-static 1.1.5.0 255.255.255.0 1.1.2.2
# Approach 2: Configure a static route on Switch A.
<SwitchA> system-view
[SwitchA] ip route-static 0.0.0.0 0.0.0.0 1.1.2.2
# Approach 1: Configure static routes on Switch B.
<SwitchB> system-view
[SwitchB] ip route-static 1.1.2.0 255.255.255.0 1.1.3.1
[SwitchB] ip route-static 1.1.5.0 255.255.255.0 1.1.3.1
[SwitchB] ip route-static 1.1.1.0 255.255.255.0 1.1.3.1
# Approach 2: Configure a static route on Switch B.
<SwitchB> system-view
[SwitchB] ip route-static 0.0.0.0 0.0.0.0 1.1.3.1
Host A
1.1.5.2/24
1.1.5.1/24
1.1.3.1/24
Switch C
1.1.2.1/24 1.1.3.2/24
Switch B
1.1.4.1/24
1.1.4.2/24
Host B
2-4