3Com 5500-EI PWR Install Manual page 1005

Network diagram
Figure 1-4 Network diagram for the FTP test
Configuration procedure
Configure FTP Server (Switch B):
Configure FTP server on Switch B. For specific configuration of FTP server, refer to the
FTP-SFTP-TFTP part of the manual.
Configure remote-ping Client (Switch A):
# Enable the remote-ping client.
<Sysname> system-view
[Sysname] remote-ping-agent enable
# Create a remote-ping test group, setting the administrator name to administrator and test tag to FTP.
[Sysname] remote-ping administrator ftp
# Configure the test type as ftp.
[Sysname-remote-ping-administrator-ftp] test-type ftp
# Configure the IP address of the FTP server as 10.2.2.2.
[Sysname-remote-ping-administrator-ftp] destination-ip 10.2.2.2
# Configure the FTP login username.
[Sysname-remote-ping-administrator-ftp] username admin
# Configure the FTP login password.
[Sysname-remote-ping-administrator-ftp] password admin
# Configure the type of FTP operation.
[Sysname-remote-ping-administrator-ftp] ftp-operation put
# Configure a file name for the FTP operation.
[Sysname-remote-ping-administrator-ftp] filename cmdtree.txt
# Configure to make 10 probes per test.
[Sysname-remote-ping-administrator-ftp] count 10
# Set the probe timeout time to 30 seconds.
[Sysname-remote-ping-administrator-ftp] timeout 30
# Configure the source IP address
[Sysname-remote-ping-administrator-ftp] source-ip 10.1.1.1
# Start the test.
[Sysname-remote-ping-administrator-ftp] test-enable
# Display test results
1-26