Lacp Configuration - NETGEAR GS724Tv3 - ProSafe Gigabit Managed Switch Admin Manual

GS716Tv2 and GS724Tv3 Software Administration Manual
Table 3-4. LAG Membership Fields (continued)
Field
Port Selection Table
Current Members
2. Click Cancel to cancel the configuration on the screen and reset the data on the screen to the
latest value of the switch.
3. If you make any changes to this page, click Apply to send the updated configuration to the
switch. Configuration changes take effect immediately.

LACP Configuration

To display the LACP Configuration page:
1. Click Switching LAG  Advanced  LACP Configuration in the navigation tree.
Figure 3-5
Table 3-5. LACP Configuration Fields
Field
LACP System Priority
2. Click Refresh to reload the page and display the most current information.
3-8
Description
Select the ports as members of this LAG.
Displays the LAGs on the current channel.
Description
Specifies the device's link aggregation priority relative to the devices at
the other ends of the links on which link aggregation is enabled. A
higher value indicates a lower priority. You can change the value of the
parameter globally by specifying a priority from 0–65535. The default
value is 32768.
v1.0, July 2009
Configuring Switching Information