Lacp Configuration - NETGEAR GS110TP - ProSafe Gigabit Smart Switch Software Administration Manual

GS108T and GS110TP Smart Switch Software Administration Manual

LACP Configuration

To display the LACP Configuration page, click Switching LAG  Advanced  LACP
Configuration.
To configure LACP:
From the LACP System Priority field, specify the device's link aggregation priority
1.
relative to the devices at the other ends of the links on which link aggregation is
enabled. A higher value indicates a lower priority. You can change the value of the
parameter globally by specifying a priority from 0–65535. The default value is 32768.
Click Refresh to reload the page and display the most current information.
2.
Click Cancel to cancel the configuration on the screen and reset the data on the screen to
3.
the latest value of the switch.
If you make any changes to this page, click Apply to send the updated configuration to the
4.
switch. Configuration changes take effect immediately.
Chapter 3: Configuring Switching Information | 15