Sntp Server Status - NETGEAR GS724Tv3 - ProSafe Gigabit Managed Switch Admin Manual

Table 2-5. SNTP Server Configuration Fields
Field
Server Type
Address
Port
Priority
Version
2. To add an SNTP server, select Add, complete the remaining fields as desired, and click Apply.
The SNTP server is added, and is now reflected in the Server list.
3. To removing an SNTP server, select the IP address of the server to remove from the Server
list, and then click Delete. The entry is removed, and the device is updated.
4. Click Cancel to cancel the configuration on the screen and reset the data on the screen to the
latest value of the switch.
5. If you change any of the settings on the page, click Apply to send the updated configuration to
the switch. Configuration changes take effect immediately.

SNTP Server Status

The SNTP Server Status page displays status information about the SNTP servers configured on
your switch.
To access the SNTP Server Status page:
Configuring System Information
GS716Tv2 and GS724Tv3 Software Administration Manual
Description
Specifies the address type of the configured SNTP server to view or
modify information about, or select Add to configure a new SNTP server.
You can define up to three SNTP servers.
Shows the format of the TFTP Server Address field The factory default is
IPv4.
Enter the IP address of the SNTP server.
Enter a port number from 1–65535. The default is 123.
Specifies the priority of this server entry in determining the sequence of
servers to which SNTP requests are sent. Enter a priority from 1–3, with
1 being the default and the highest priority. Servers with lowest numbers
have priority.
Enter the protocol version number. The range is 1–4.
v1.0, July 2009
2-11