Secure Http Configuration - NETGEAR GS724Tv3 - ProSafe Gigabit Managed Switch Admin Manual

GS716Tv2 and GS724Tv3 Software Administration Manual
Table 5-11. HTTP Configuration Fields
Field
Java Mode
HTTP Session Soft Timeout This field is used to set the inactivity timeout for HTTP sessions. The
HTTP Session Hard
Timeout
Maximum Number of HTTP
Sessions
2. Click Cancel to cancel the configuration on the screen and reset the data on the screen to the
latest value of the switch.
3. If you make changes to the page, click Apply to apply the changes to the system.

Secure HTTP Configuration

Secure HTTP enables the transmission of HTTP over an encrypted Secure Sockets Layer (SSL) or
Transport Layer Security (TLS) connection. When you manage the switch by using a Web
interface, secure HTTP can help ensure that communication between the management system and
the switch is protected from eavesdroppers and man-in-the-middle attacks.
Use the Secure HTTP Configuration page to configure the settings for HTTPS communication
between the management station and the switch.
To display the Secure HTTP Configuration page:
1. Click Security  Access, and then click the HTTPS  HTTPS Configuration link.
5-16
Description
This select field is used to Enable or Disable the Web Java Mode. This
applies to both secure and un-secure HTTP connections. The currently
configured value is shown when the Web page is displayed. The default
value is Enable.
value must be in the range of (0–60) minutes. A value of zero
corresponds to an infinite timeout. The default value is 5 minutes. The
currently configured value is shown when the Web page is displayed.
This field is used to set the hard timeout for HTTP sessions. This
timeout is unaffected by the activity level of the session. The value must
be in the range of (0–168) hours. A value of zero corresponds to an
infinite timeout. The default value is 24 hours. The currently configured
value is shown when the Web page is displayed.
This field is used to set the maximum allowable number of HTTP
sessions. The value must be in the range of (0–16). The default value is
16. The currently configured value is shown when the Web page is
displayed.
v1.0, July 2009
Managing Device Security