Mac Filter - NETGEAR GS724Tv3 - ProSafe Gigabit Managed Switch Admin Manual

1. Click Security  Traffic Control, and then click the MAC Filter  MAC Filter
Configuration link.
Figure 5-18
Table 5-20. Switch Configuration Fields
Field

MAC Filter

VLAN ID
MAC Address
Source Port
Members
Destination Port
Members
Managing Device Security
GS716Tv2 and GS724Tv3 Software Administration Manual
Description
This is the list of MAC address and VLAN ID pairings for all configured filters. To
change the port mask(s) for an existing filter, select the entry you want to
change. To add a new filter, select "Create Filter" from the top of the list
The VLAN ID used with the MAC address to fully identify packets you want
filtered. You can only change this field when you have selected the "Create
Filter" option.
The MAC address of the filter in the format 00:01:1A:B2:53:4D. You can only
change this field when you have selected the "Create Filter" option.
You cannot define filters for these MAC addresses:
• 00:00:00:00:00:00
• 01:80:C2:00:00:00 to 01:80:C2:00:00:0F
• 01:80:C2:00:00:20 to 01:80:C2:00:00:21
• FF:FF:FF:FF:FF:FF
Click the orange bar to display the available ports. Select the ports you want
included in the inbound filter. If a packet with the MAC address and VLAN ID
you selected is received on a port that is not in the list, it will be dropped.
Click the orange bar to display the available ports. Select the ports you want
included in the outbound filter. Packets with the MAC address and VLAN ID you
selected will only be transmitted out of ports that are in the list. Destination ports
can be included only in the Multicast filter.
v1.0, July 2009
5-31