Secure Http Configuration - NETGEAR GS110TP - ProSafe Gigabit Smart Switch Software Administration Manual

In the HTTP Session Hard Timeout field, specify the hard timeout for HTTP sessions.
3.
This timeout is unaffected by the activity level of the session. The value must be in the
range of (0–168) hours. A value of zero corresponds to an infinite timeout. The default
value is 24 hours. The currently configured value is shown when the Web page is
displayed.
In the Maximum Number of HTTP Sessions field, specify the maximum number of HTTP
4.
sessions that can exist at the same time. The value must be in the range of (0–16). The
default value is 16. The currently configured value is shown when the Web page is
displayed.
Click Cancel to cancel the configuration on the screen and reset the data on the screen to
5.
the latest value of the switch.
If you make changes to the page, click Apply to apply the changes to the system.
6.

Secure HTTP Configuration

Secure HTTP enables the transmission of HTTP over an encrypted Secure Sockets Layer
(SSL) or Transport Layer Security (TLS) connection. When you manage the switch by using
a Web interface, secure HTTP can help ensure that communication between the
management system and the switch is protected from eavesdroppers and man-in-the-middle
attacks.
Use the Secure HTTP Configuration page to configure the settings for HTTPS
communication between the management station and the switch.
To display the Secure HTTP Configuration page, click Security  Access, and then click the
HTTPS  HTTPS Configuration link.
To configure HTTPS settings:
Use the radio buttons in the HTTPS Admin Mode field to enable or disable the
1.
Administrative Mode of Secure HTTP.
158 | Chapter 5: Managing Device Security
GS108T and GS110TP Smart Switch Software Administration Manual