Service Manual
Drive Unit and Optical Unit Removal
3.2.6
This section describes how to remove the drive unit and the optical unit.
3.2.6.1 Drive Unit Removal
Remove the rear cover. (Refer to Section 3.2.l.l.)
1.
2. Remove the top cover. (Refer to Section 3.2.l.2.)
3. Remove the left cover. (Refer to Section 3.2.l.3.)
Remove the nghtcover. (Refer to Section 3.2.l.4.)
4.
5. Remove the ELEC cover. (Refer to Section 3.2.2.l.)
6. Remove the fusing unit. (Refer to Section 3.2.5.l.)
7. Discomect connector P/J14 from theengine driver board (MCUPWB board).
8. Remove 3 CBB screws (M3 x 29) and 1 CBB screw (M3
remove it.
Rev. A
Figure 3-46. Removing the Drive Unit
Disassembly and Assembly
12) securing the drive unit, and
x
3-29