Drive Unit Removal - Epson EPL-N2700 Service Manual

EPSON EPL-N2700 / N2750

4.2.22 Drive Unit Removal

1. Separate the printer. (See Section 4.2.6.)
2. Remove the Rear Cover. (See Section 4.2.6.)
3. Remove the Top Cover. (See Section 4.2.11.)
4. Remove the Front Cover. (See Section 4.2.17.)
5. Remove the Transport Motor. (See Section 4.2.7.)
6. Remove the I/C Drive Motor. (See Section 4.2.8.)
7. Remove the Fuser Unit. (See Section 4.2.21.1.)
Figure 4-54. Fuser Unit Reinforce Plate Removal
Disassembly/Assembly
8. Disconnect the fusing roller thermistor harness and the paper eject
sensor harness which are connecting to the Fuser Unit Reinforce
Plate from the relay connectors.
9. Remove 5 screws (3506; two at the front and three at the rear)
securing the Fuser Unit Reinforce Plate to the printer frame, and
remove the Fuser Unit Reinforce Plate. (See Figure 4-54.)
10. Remove three screws (3501) securing the Drive Unit Cover
(mounting plate) to the printer frame and remove the mounting
plate. (See Figure 4-55.)
Disassembly Procedure
al
3501
Figure 4-55. Drive Unit Cover Removal
Revision B
131