Service Manual
3.2.3.4 Feed Roller Assembly Removal
Remove the paper cassette and imaging cartridge.
1.
2. Remove the feeder assembly. (Refer to%ction 3.2.3.1.)
3. Remove 2 CBB screws (M3 x 8) securing the feeder tie plate, and remove it.
4. Remove 2 CBB screws (M3 x 8) and 2 CB screws (M3 x
and remove it.
5. Remove the GEAR IN and GEAR OUT.
6. Remove the E-ring (left) securing the feed roller assembly, and remove it.
Figure 3-17. Removing the Feed Roller Assembly
3.2.3.5 Feed Roller Removal
Remove the paper cassette and imaging cartridge.
1.
2. Remove the feeder assembly. (Refer to Section 3.2.3.1.)
3. Push the plastic face of the feed roller while holding the shaft of the feed roller assembly, and
remove the feed roller from the assembly.
Rev. A
Figure 3-18. Removing the Feed Roller
Disassembly and Assembly
8)
securing the feed housing (right),
3-13